Bosch ATM/POS Bridge - Manual (Page 18)

Bosch Security Systems
ATM/POS bridge | Installation Manual EN | 12
Eng
lish
4. Troubleshooting
If you are unable to capture transaction data, perform the following steps:
1. Recheck your cables.
2. Check your TCP/IP network connection with the ATM/POS bridge. Check your
gateway and subnet mask settings, they must match the digital recorder settings.
3. If the recorder has established communication with your bridge and you still cannot
capture the transaction data, use the simulation mode of the bridge in the System
Options Menu. The bridge will send sample transactions to the recorder in this
mode.
4. Check the COM ports settings in your bridge. If the transaction data is being
recorded, but shows the wrong characters, check the COM port settings. The
language setting must be the same as the recorder language setting.
5. If your recorder requires an ATM/POS software license (for example, the Divar 2
digital versatile recorder), please check if this license is enabled in the System
Settings - Licenses submenu of the Divar.