Bosch ATM/POS Bridge - Manual (Page 15)

Bosch Security Systems
ATM/POS bridge | Installation Manual EN | 9
English
Communication Channels
In the Communication Channels submenu you can select one of the four COM ports to
configure. The submenu that appears depends on the setting of the Comport Mode. Enter
the parameters that are required for your terminal.
Terminal Setup
In the Terminal Setup submenu you can select one of the four connected terminals to
configure. Enter a terminal name and select the type of device connected to your
terminal. Contact your local sale representative if your device is not listed in the menu
for selection. Our firmware is continously extended with new options.
Simulation Mode
The Simulation Mode is used to test the connection between the bridge and the digital
recorder. If this mode is selected, sample data is sent from the bridge to the digital
recorder.
1 Comport Mode Asynchronous
3 Baudrate 9600
4 Databits 8 bits
5 Parity None
6 Stop bits 1bit
7 Flow Control Off
1 Name TERMINAL-01
2 Device Epson TM-T88III (example)
3 Comm Channel Com 1 - RS232
4 Address 0