Belkin F5D5010 - Manual (Page 5)

Installing the Hardware
2
Installing the Notebook Network Card in PCs with CardBus Slots
1. Turn off the power to the notebook.
2. Insert the Notebook Network Card in the CardBus slot of
your notebook.
3. Connect the Notebook
Network Card’s adapter into
the connector on the rear of
the card.
4. Connect the other end of the
CAT5 cable and RJ45 plug
into the network device.
Note: A standard Belkin network cable cannot be used to directly
connect two computers. A specially wired cable called a crossover
cable is needed to allow you to connect two computers without
the use of a network hub or switch. Belkin crossover cables are
yellow (Belkin’s A3X126-XX-YLW-M).
P73635-F5D5010-man.qxd 6/4/01 4:54 PM Page 2