Beaumont Products MPEG - 4 - Manual (Page 11)

V B R I C K E T H E R N E T V S E T T O P B O X U S E R S G U I D E V E R S I O N 3 . 6 . 9
Video
Video: Setup
These settings enable or change these and other selections:
Boot Mode – There are three supported
modes:
1
MCS – If the installation includes the
EtherneTV Media Control Server,
this selection should be set.
Local – If the installation is for an
EtheneTV Set Top Box connected
directy to a network, this selection
should be set.
Local-Fullscreen – If the
installation is for an EtherneTV Set
Top Box tuned to one channel, this
selecton should be set.
NOTE: If Local-Fullscreen
mode is selected, a Receive
Address must also be entered.
MCS Location – If the set top box is part of an installation that includes an MCS, enter the
IP address of the MCS server here.
Main Volume – Change the volume level if desired.
Line 1 Volume – Change the volume level if desired.
Receive Address – The receive address or URL of the desired video.
NOTE: A Receive Address must be entered if Local-Full Stream mode is selected.
Display
There are no user configurable parameters
in the Display: General and the Display:
Resolution settings.
C O P Y R I G H T V B R I C K S Y S T E M S P A G E 1 1 N O V E M B E R 1 0 , 2 0 0 3