beautypg.com

7cleaning and care, Detergent drawer, The door and the drum – Beko WMC62W User Manual

Page 24: Outer cabinet and control panel, Inlet water filters

background image

24

EN

Detergent drawer

Remove any powder residue buildup in

the drawer. To do this;

1. Press the dotted point on the siphon

in the softener compartment and pull

towards you until the compartment is

removed from the machine.

C If more than a normal amount of

water and softener mixture starts to

gather in the softener compartment,

the siphon must be cleaned.

2. Wash the dispenser drawer and the

siphon with plenty of lukewarm water

in a washbasin. Wear protective

gloves or use an appropriate brush

to avoid touching the residues in the

drawer when cleaning.

3. Replace the drawer into its housing

after cleaning. Check if the siphon is

in its original location.

The door and the drum

After each wash:

• Check if there are any foreign

substances in the drum.

• Open the hole in the bellow with the

aid of a toothpick if it is clogged.

C Foreign metal substances in your

machine can cause rust stains. In

such cases:

Clean the drum with a stainless steel

cleaning agent. Never use steel wool

or wire wool.

Outer cabinet and control

panel

When necessary:

• Wipe the exterior panels of your

machine with soapy water or mild

detergent. Dry it with a soft cloth.

• Use only a soft and damp cloth to

clean the control panel.

C Never use a sponge or scrubbing

material. These will damage the

painted and plastic parts.

Inlet water filters

There is a filter at the end of each

water intake valve at the back side of

the machine and also at the end of

each water intake hose where they

are connected to the tap. These filters

prevent the foreign substances and dirt

in the water to enter into the machine.

Filters should be cleaned as they get

dirty.

• Close the taps.

• Remove the nuts of the water intake

hoses to clean the surfaces of the

filters on the water intake valves with

an appropriate brush.

• If the filters are very dirty, you can

pull them out by means of pliers and

clean them.

• Take out the filters on the flat ends of

the water intake hoses together with

the gaskets and clean thoroughly

7

Cleaning and care

This manual is related to the following products: