Beko WMC62W - Manual (Page 20)

20 EN
selecting the washing program. The
“Program finished” lamp illuminates
and the “Wash” light will fade when the
program comes to an end. The “Lid”
light flashes. Meanwhile, the door will
stay locked for your safety and when it
is safe to open, the “Lid” and “Program
Finished” lights remain on.
You can put your machine into “Pause”
mode by pressing the “Start/Pause/
Cancel” button when it is operating.
In this case, the “Start/Pause/Cancel”
light will flash. Some changes in
program settings can be made in pause
mode (See. Changing a Program)
and if “Pause” mode is entered at an
appropriate step of the program, the
adding laundry function may be used.
(See, Adding and taking out laundry).
Press “Start/Pause/Cancel” button
again to return to the “Wash” mode
from “Pause” mode. In this case the
“Start/Pause/Cancel” button will light
up continuously and the machine will
resume operating from the step it was
paused.
•If the machine is not spinning, the
program may be in rinse hold mode
or the automatic spin correction
system has been activated because
of unbalanced distribution of laundry
in the machine.
Changing the program after
the program has started
You can use this feature after your
machine has started to wash different
textile groups in the same batch
of clothes under higher or lower
temperatures.
For example;
Press and hold the “Start/Pause/
Cancel” button for 3 seconds to
“Cancel” the program in order to
select “Cottons 40” program instead of
“Cottons 60” program.
Select the “Cottons 40” program by
rotating the program knob.
Press “Start/Pause/Cancel” button to
start the program.
C The program which is selected
first will go on even if the program
selection button is moved and
another program mode is selected
while the machine is operating. You
must cancel the ongoing program
in order to change the washing
program. (See, Canceling a Program)
Selecting or cancelling an auxiliary
function/temperature/spin speed
1. Press the “Start/Pause/Cancel”
button to switch the machine to
“Pause” mode.
2. Change the auxiliary function’s
temperature and spin speed.
Press “Start/Pause/Cancel” button to
start the program.
C The selection to be made must be
appropriate. For example, if your
machine is on the main wash cycle,
you may select additional rinse
auxiliary function, but you cannot
select pre-wash.
C The spin speed and temperature
which are selected first will keep on
being valid even if the position of the
spin speed or temperature selection
knob is changed. Press the “Start/
Pause/Cancel” button and switch
the machine to “Pause” mode in
order to change the spin speed or
temperature. New spin speed or
temperature can be selected.
Adding/removing laundry in standby
mode
If you want to add more laundry into the
machine after the washing cycle has
started, put the machine into “Pause”
mode by pressing the “Start/Pause/
Cancel” button. The “Lid” lamp on the
program follow-up indicator will light up
steadily after 1-2 minutes if the water
level in the machine is suitable. Laundry
may be added or taken out by opening
the door. If the “Lid” lamp does not
light up continuously at the end of this
time, the water level in the machine
is not suitable and laundry cannot be
added. You can resume the program
by pressing the “Start/Pause/Cancel”
button again.