Beko WMC62W - Manual (Page 22)

22 EN
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Place the laundry in the machine.
3. Add detergent and softener.
Starting
1. Press the “On/Off” button.
2. Select the programme and the
temperature.
3. If required (according to your
machine’s model):
– select any auxiliary function,
– adjust the spin speed,
– set the time delay,
4. Close the loading door.
5. Press Start/Pause/Cancel button.
Canceling a program
• Press “Start/Pause/Cancel” button
for 3 seconds. The machine starts
to discharge the water. “Wash” and
“Program Finished” lights will light up.
• “Start/Pause/Cancel” and “Wash”
lights will go off after discharging
process is over and the “Lid” light will
start flashing.
• If the program is cancelled in the
middle of the process, “Wash” and
“Program Finished” lights will light
up. The machine can drain all the
water or can take in water for 3 times
at most to cool down the clothes
and complete draining process.
When water discharging process is
completed, “Wash” light will go off,
“Program Finished” light will light up
and the “Lid” light will continuously
flash until the door is allowed to
be opened. You can make a new
program selection when the “Lid” light
is lit continuously.
Adding more laundry
You may add more laundry into the
machine at the beginning of washing.
C Machine allows adding more laundry
during a later step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low enough.
In order to add laundry after the start-up
of the program:
1. Press Start/Pause/Cancel button.
Wait until the door is allowed to open.
“Lid” lamp will light up continuously
when the door is allowed to open.
2. Open the loading door and put in
more laundry.
3. Close the loading door.
4. Press Start/Pause/Cancel button.
Program is in rinse hold mode
C After the machine fills with water in
the final rinse step, clothes can be
soaked in the machine as long as
desired.
When it reaches this position while the
machine is running, the “Start/Pause/
Cancel” light will flash.
In the machines equipped with spin
speed selection knob, you can spin by
selecting the desired spin speed and
press “Start/Pause/Cancel” button.
As for machines not equipped with a
spin speed selection knob, you can
end the program without spinning by
pressing the “Start/Pause/Cancel”
button to drain the water. You may spin
your clothes whenever you wish to by
selecting the spin program.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
If you want to re-spin the clothes:
1. Rearrange the previously placed
clothes in machine.
2. Select Spin+Pump program.
3. Set the spin speed if spin speed
adjustment is available on your
machine.
4. Press “Start/Pause/Cancel” button.
After the program is finished
1. “Program finished” lamp will light up
on the program follow-up indicator.
6 Quick instructions for daily use