Bryston BR2 - Manual (Page 2)

BR2 HANDHELD INFRA-RED REMOTE CONTROL
for use with the following Bryston models:
• BCD-1 CD player
• BDA-1 Digital-to-Analog Converter
• B60R Integrated Amplifier / BP6 Preamp
• B100 Integrated Amplifier / BP16 Preamp
• BP26 Preamp
FEATURES:
● Powered by two “AAA” batteries.
ReplacebatterybyremovingbottomcoverplatebyremovingthefourPhilipsscrewsontherearoftheremoteunit.
● Automatic motion-sensing backlight.
Canbedisabledbyenteringthe3digitcode“792”
● Power saving ambient light level sensor inhibits backlight when not needed.
● Solid machined aluminum enclosure and push buttons.
● Can be used with over 7 different Bryston amps & preamps
● Special function codes customize preformance
PROGRAMMING the BR2 REMOTE CONTROL:
1st) Press and hold the CODE button on the BR2 remote until the red LED begins to flash (usually takes about 5
seconds).
2nd) Enter a three digit code as follows:
7xx: SP2 PreAmp/Processor
712: B100 integrated amplifier
715: BCD-1 *
721: BP26 preamp *
722: B60R integrated amplifier & BP6 preamp
Other codes:
792: Disable motion sensor backlight control
797: Enable motion sensor backlight control
The red LED will flash twice after a code has been entered successfully.
* See also Model Select Buttons below.
MODEL SELECT BUTTONS:
The D/A, CD and PREAMP buttons allow switching BR2 operation directly amongst Bryston’s BDA-1, BCD-1 and various
Bryston Preamps (depends on which one has been previously selected using the codes above).
PROGRAMMING/CONTROLLING the B100/BP16 via the BR2 REMOTE CONTROL:
Press the CODE button on the remote control until the red LED lights and then enter the 3 digt code as listed below. The LED
will flash to confirm transmission and then extinguish.
001: select analog source 1 (A/D) 019: balance left 082: select digital source 2 (D2)
002: select analog source 2 (AUX/PH) 020: balance right 083: select digital source 3 (D3)
003: select analog source 3 (CD) 029: power on 084: select digital source 4 (D4)
004: select analog source 4 (TUNER) 058: mute on 245: set/reset Pass Through mode
005: select analog source 5 (TV) 059: mute off 247: Set Trigger 2 for current source
006: select analog source 6 (VIDEO) 061: record monitor toggle 248: Clear Trigger 2 for current source
007: volume up 062: record monitor on 255: System reset; restore defaults
008: volume down 063: record monitor off
While most of these codes are primarily intended for controlling the B100/BP16 via it’s RS232 port (with system control-
lers such as those provided by Crestron or AVX, etc) they can also be sent via the BR2 infra-red remote.
For more information see the B100 Owners Manual or the BP16 Owner’s Manual.