Neff S66M63N1GB - Manual (Page 33)

Installation and connection en
33
Delivery
Your dishwasher has been checked
thoroughly in the factory to ensure that it
is in working order. This may cause
small water stains. These will disappear
after the first wash cycle.
Technical specifications
Weight:
max. 27 kg
Voltage:
220–240 V, 50 Hz or 60 Hz
Connected load:
2.0–2.4 kW
Fuse:
10/16 A (UK 13A)
Power input:
switched off 0.1 W
not switched off 0.1 W
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
Preferably cold water; if hot water,
depending on type of water inlet hose,
max. temp. 60 °C (see Fresh water
connection).
Installation
The required installation dimensions can
be found in the installation instructions.
Level the appliance. Ensure that the
appliance is situated securely on the
floor.
The appliance can easily be
installed in a fitted kitchen between
wooden and plastic walls.
Waste-water connection
1. The required work sequence can be
found in the installation instructions.
If required, fit a siphon with an
drainage connection.
2. Connect the waste-water hose to the
drainage connection of the siphon
with the enclosed parts.
Ensure that the drainage hose is not
kinked, crushed or twisted and that
there is no cover plate in the
drainage to prevent the waste water
from flowing out!
Fresh water connection
1. Connect the fresh-water connection
to the tap according
to the installation instructions with
the enclosed parts.
Ensure that the fresh-water
connection is not kinked,
crushed or twisted.
2. When replacing the appliance,
always use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute