Neff S66M63N1GB - Manual (Page 29)

Fault, what to do? en
29
Coloured (yellow, orange,
brown), easily removable
deposits inside
the appliance (mainly
in the floor area). Film formation consisting
of ingredients from food
remnants and substances from
the tap water (limescale), “soapy” Check function of the water softening
system (refill with salt) or, if using combined
detergents (tablets), activate water
softening system (see chapter Water
softening system/Special salt).
Plastic parts discoloured. Too low rinsing temperature. Select programme with higher washing
temperature.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed. Do not prerinse utensils. Remove only large
food remnants.
Recommended programme Eco 50°
Removable streaks on
glasses, glasses with
metallic appearance and
cutlery. Too much rinse aid. Set rinse aid amount to lower setting.
No rinse aid added or setting too
low. Add rinse aid and check dosage
(recommended setting 4-5).
Detergent residue in the final
rinse programme section.
Detergent dispenser cover
blocked by utensils (cover does
not open fully). Detergent dispenser cover must not be
obstructed by utensils.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed. Do not prerinse utensils. Remove only large
food remnants.
Recommended programme Eco 50°
Initial or existing,
irreversible clouding
of glass. Glasses not dishwasher-proof,
only suitable for dishwasher. Use dishwasher-proof glasses.
Avoid long steam phase (standing time after
wash cycle ends).
Use wash cycle at lower temperature.
Set water softening system according to the
water hardness (if required one setting
lower).
Use detergent with glass protection
component.
Fault Cause Remedial action