Neff S66M63N1GB - Manual (Page 26)

en Fault, what to do?
26
Utensils not dry. No or too little rinse aid in
the dispenser. Refill rinse aid.
Programme selected without
drying. Select programme with drying (see
Overview of programmes, Programme
sequence).
Water collecting in depressions
on the utensils and cutlery. Arrange utensils in a sloping position,
arrange affected utensils as sloping
as possible.
The combined detergent used
has a poor drying performance. Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Intensive drying to increase
drying not activated. Activate intensive drying (see Operating
the appliance)
Utensils were removed too early
or drying process had not ended
yet. Wait until program ends or wait until 30 min
after program ends before removing
utensils.
The eco rinse aid used has a poor
drying performance. Use a proprietary rinse aid. Eco products are
much less effective.
Plastic utensils not dry. Special properties of plastic. Plastic has a lower heat storage capacity
and therefore dries less well.
Cutlery not dry. Cutlery not arranged properly
in the cutlery basket. Separate cutlery if possible, prevent contact
points.
Appliance interior wet after
rinse cycle. No appliance fault. On account of the “Condensation drying”
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
Fault Cause Remedial action