Neff W7460X1GB - Manual (Page 23)

Faults and what to do about them. en
23
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the washing machine door
if water can be seen through the glass.
1. Set the programme selector to the
Off position. Remove the mains plug.
2. Drain the water.
Pull the emergency release
downwards with a tool and release.
The washing machine door can then be
opened.
Information on the display panel
Display Cause/remedial action
I flashes Close the washing machine door properly; laundry may be caught.
YES + I The washing machine door is unlocked. It is possible to add laundry.
NO
■
Due to the high temperature in the drum, the washing machine door cannot
be opened. Wait until the temperature drops.
■
Due to the high level of water in the drum, the washing machine door can-
not be opened. Drain the water (e.g. select the Spin or Empty programme (if
only a drain cycle is required, set rpm (spin speed) to 2 (without final spin)
= $ (Rinse hold)).
E:17
E:29
■
Turn on the cold water tap fully
■
Supply hose kinked or trapped
■
Water pressure too low. Clean the filter.
A:10
■
Turn on the hot water tap fully, supply hose kinked or trapped.
■
Supply hose kinked/jammed; water pressure too low. Clean the filter.
■
Hot water hose not connected; washing machine will operate using cold
water only. Ignore information, this message is only displayed for the first
wash cycle.
E:18
■
Detergent solution pump blocked. Clean the detergent solution pump.
■
Drain hose/waste pipe blocked. Clean the drain hose on the siphon.
E:23 Water in the base trough due to appliance leaking. Call the after-sales service.
w
If childproof lock is active, deactivate it.
x ~ flashes; too much foam detected?
Other displays Switch off the appliance, wait for five seconds and switch it back on again. If the
display is indicated again, call the after-sales service.