Neff W7460X1GB - Manual (Page 22)

en Faults and what to do about them.
22
The drain hose at the siphon
is blocked
1. Switch off the appliance. Disconnect
the mains plug.
2. Loosen the hose clamp. Carefully
remove the drain hose, residual
water may leak out.
3. Clean the drainage hose and siphon
connecting piece.
4. Reattach the drainage hose and
secure the connection using the
hose clamp.
Filter in the water supply
blocked
For this, first reduce the water pressure
in the supply hose:
1. Turn off the tap.
2. Select any programme (except
Rinse, Spin, Empty.
3. Press the Start button. Allow the
programme to run for approximately
40 seconds.
4. Set the programme selector to the
Off position. Remove the mains plug.
5. Clean the filter on the water tap:
Remove the hose from the water tap.
Clean the filter with a small brush.
6. For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance,
Remove the filter using pliers and
clean the filter.
7. Connect the hose and check for
leaks.
3 Faults and what to do
about them.
Faults an d what to do about them.
Emergency release
E.g. in the event of a power cut
The programme continues running
when the power supply is restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot
detergent solution and laundry.
If possible, leave it to cool down.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is rotating.
Do not reach into the drum while it is
rotating. Wait until the drum has
stopped rotating.