Neff W7460X1GB - Manual (Page 21)

Cleaning and maintenance en
21
Allow the detergent solution to cool
down.
1. Turn off the water tap so that no
more water can flow in and has to be
drained via the detergent solution
pump.
2. Switch off the appliance and pull out
the mains plug.
3. Open and remove the service flap.
4. Fold out the water gutter in front of
the pump cover.
5.
– Remove the drainage hose from
its holder and remove the sealing
cap.
Allow the detergent solution to
flow out into a suitable container.
Replace the sealing cap on the
drainage hose and place the
drainage hose back in the
retainer.
– Without the drainage hose
Carefully turn the pump cover
once through 180°, but do not
remove it. The water now runs out
of the detergent solution pump.
Repeat the process until no more
detergent solution flows out.
6. Now carefully unscrew the pump
cover. Residual water may run out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle should be vertical.
7. Fold in the water gutter.
8. Place the service flap back on, lock
it into place, and close it.
Note: To prevent unused detergent
from flowing straight into the drain
during the next wash: Pour 2 litre of
water into compartment II and start the
Empty programme.