Sharp UP-X200 - Manual (Page 43)

41
Applying the Regulatory Country Stamp
A regulatory label is applied to signify the device is approved for use in the following countries:
United States, Canada, Australia, New Zealand, Japan & Europe.
Note: Europe includes, Austria, Belgium, Croatia, Denmark, Estonia, Finland, France, Germany,
Greece, Iceland, Ireland, Italy, Liechtenstein, Luxembourg, Netherlands, Norway, Portugal, Spain,
Sweden, Switzerland, United Kingdom.
In addition to the list above other countries may require a regulatory stamp to be affixed to the product.
Please refer to www.symbol.com/ for the list of countries where mandatory stamps are required.
For countries that require regulatory label, a sheet of stamps may be enclosed within the package.
If the appropriate stamp is not provided, please contact your supplier.
To apply the country stamp:
1. Peel the stamp appropriate to the country where this device is to be used.
2. Apply the country stamp in the space provided on the wireless card regulatory label.
Operation of the device without a regulatory label or the correct country Stamp is illegal.
Regulatory Compliance
Symbol RF products are designed to be compliant with the rules and regulations in the locations into
which they are sold and will be labeled as required. The majority of Symbol RF devices are type
approved and do not require the user to obtain license or authorization before using the equipment. Any
changes or modifications to Symbol Technologies equipment not expressly approved by Symbol
Technologies could void the user authority to operate the equipment.
Radio Frequency Interference Requirements
This device has been tested and found to comply with the limits for a Class B digital device pursuant to
Part 15 of the Federal Communications Commissions (FCC) Rules and Regulation. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
However, there is no guarantee that interference will not occur in a particular installation.
If the equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that which the receiver is connected.
The Regulation of this Radio LAN card is as the following.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions :
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This product contains an approved Radio LAN card of Regulations. Type:LA-4137.
The Regulation of Radio LAN card Type:LA-4137 is as the following.
UPX200_ENDpage 04.7.15, 2:45 PM 41