Brother P-touch PT-2700 - Manual (Page 77)

1
2
3
4
5
6
7
8
9
75
z
TRO
U
BLESHOOTING
Error Messages
When an error message appears on the display, follow the directions provided below.
Error Messages
Press any key to clear the error message.
Message Cause/Remedy
The installed batteries are getting weak.
• The batteries are installed with the negative and positive
end in the wrong position, or other type batteries are mixed
with alkaline batteries. Install eight AA-size alkaline
batteries (LR6) in the correct position.
• The installed batteries are about to run out. Replace with
new batteries or connect the AC adaptor before continuing.
An incompatible AC adaptor is connected. Use only the AC
adaptor designed exclusively for your P-touch.
The tape cutter is closed when you try to print or feed tape.
Turn the P-touch off and then on again before continuing.
When tape is tangled in the cutter, remove the tape.
There is no text, symbols or bar code data entered when you
try to print or preview a label. Enter data before continuing.
There is no tape cassette installed when you try to print or
preview a label, or feed tape. Install a tape cassette before
continuing.
The tape cassette was changed while printing, etc. Make
sure the correct tape cassette is inserted before printing.
There are already seven lines of text when you press the
key. Limit the number of lines to seven.
There are more than five lines of text when you press the
or key while using 18mm (3/4") tape. Limit the
number of lines to five, or change the tape cassette for one
with a larger tape cassette.