Black & Decker CO100B User Manual

Page 6

3. To remove the can, hold it with one hand and raise the lever with the other.
Caution: Avoid contact with the cut edges of the can or lids — they are sharp.

During opening process, the design of your can opener will roll the rim of the can to

prevent sharp edges; however, handle with caution and always handle cut lid with

caution, as these edges are not rolled.
4. Carefully discard the lid from the magnet.
Important Tips:
• Do not use this can opener to open cans with a pull tab, peel-off foil seal,

or rolling key or rimless cans.
• Open frozen juices or foods in cardboard cans right from the freezer, while they

are frozen.
• Aluminum lids will not stick to the magnet.
USING THE KNIFE SHARPENER
1. For best results, sharpen the entire blade length in one continuous stroke.
2. Insert blade to be sharpened with the end of the blade closest to the handle on the

knife into the sharpening slot.

3. Carefully press down on the blade and pull it toward you through the slot in one

continuous stroke

(N).

Important: Do not saw knife back and forth to sharpen. Pull through the sharpener

in one direction with a continuous, slow, even motion. Failure to do so may dull or

damage your blade.
4. Repeat until desired sharpness is achieved.
5. Wash and dry knife before using again.
Important Tips:
• Use caution when washing and drying knives after sharpening.
• Do not sharpen serrated blades, as this will smooth their edges.
• Do not sharpen scissors.

USING THE BOTTLE OPENER
1. Grasp the bottle and position cap above the lip on the back side of the bottle

opener.

2. Tilt bottom of the bottle away from you to catch the cap on the lip and open the

bottle

(P).

USING THE BAG CUTTER
1. Grasp the plastic or metal foil bag to be opened by one corner, with one hand

holding the top edge and the other holding the side or bottom, depending on the

size of the bag.

2. Position tightly pulled corner of bag against the cutter and pull firmly to the left to

open the bag

(Q).

Note: Pulling a bag straight against the cutter will cut a line along the top of the bag;

pulling at an angle will simply remove the corner.