Black & Decker CO100B User Manual
Page 3
4
GETTING STARTED
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting washers, screws and spacers for mounting and set them
aside in a safe place where they will not roll away or get lost.
Important: Do not attempt to operate appliance until it is properly installed.
CHOOSE A LOCATION
When choosing your location, consider the following:
•
DO make sure to mount within reach of an electrical outlet.
•
DO consider your normal work patterns in the kitchen when choosing
location.
•
DO account for whether or not you will be mounting other appliances and
connecting them together, using the rear outlet on the coffeemaker and/or
toaster oven.
•
DO NOT mount over any heating or cooking appliance such as your range or
oven.
•
DO NOT mount over or near a sink.
•
DO NOT mount under, in front of or behind any under-cabinet light fixtures.
Note: If you’re mounting multiple †SpaceMaker™ appliances, they may be
mounted directly flush against each other or with space in between, whichever
you prefer.
Note: If connecting multiple †SpaceMaker™ appliances together, always put the
appliance with the female receptacle at the rear of the unit near the outlet.
DETERMINE CABINET TYPE
Prior to taping the mounting template and beginning to drill your holes, determine
if your cabinet has a flat bottom
(B) or an overhanging lip (C). If your cabinet is
flat, follow STANDARD INSTALLATION; if the cabinet has a lip, refer to SPACER
MOUNTING INSTALLATION.
STANDARD INSTALLATION (FLAT CABINET)
Important: Always wear protective glasses or goggles to prevent injury when
drilling.
1. Clear countertop under installation area to avoid getting dust or debris on other
appliances or items. Open cabinets and remove contents to make mounting
easier.
3
Product may vary slightly from what is illustrated.
1. Bag cutter
2. Knife sharpener
3. Bottle opener
4. Cover
† 5. Blade assembly with magnet
(Part # CO100-01)
6. Locating post
7. Piercing lever
8. Cord storage (behind unit)
9. Cord management hook (behind unit)
†Consumer replaceable/removable parts
A1
† 1. Mounting Parts
(Part # SDC-MOUNTING KIT)
16 Spacers
4 ½"
4 ¼"
4
3
/
16
"
4
1
/
16"
12 Screws
4 1"
4 1½"
4 2¼"
4 Washers
2. Mounting Template (in box)
A2
B
C