Black & Decker AS700 - Manual (Page 5)

8 7
5. Presione y sostenga el botón de limpieza automática
(auto cLean). tenga cuidado, ya que saldrá agua
caliente y vapor de los orificios de vapor (J). Mantenga
presionado el botón de limpieza automática (auto
cLean) hasta vaciar toda el agua y los depósitos
minerales. Si es necesario, puede mover la plancha de
lado a lado o de atrás para adelante.
6. cuando termine, suelte el botón, coloque la plancha sobre el talón de
descanso y enchufe. Permita que la plancha se caliente unos 2 minutos para
asegurarse de que toda el agua se haya secado.
ALMACENAJE DE LA PLANCHA
1. desconecte y permita que la plancha se enfríe bien.
2. asegúrese que el selector se encuentre ajustado a la posición
.
3. coloque la plancha verticalmente sobre el talón de descanso para evitar que
la suela gotee.
J When using your iron, basic safety precautions should always be followed,
including the following:
□ read aLL inStructionS BeFore uSinG.
□ use iron only for its intended use.
□
to protect against a risk of electric shock, do not immerse the iron in
water or other liquid.
□
the iron should always be turned off (refer to "How to use" section)
before plugging into or unplugging from an outlet. never yank cord to
disconnect from outlet; instead grasp plug and pull to disconnect.
□ do not allow cord to touch hot surfaces. Let iron cool completely before
putting away. Loop cord loosely around cord wrap when storing.
□ always disconnect iron from electrical outlet when filling with or emptying
of water, and when not in use.
□
do not operate iron with a damaged cord or if the iron has been dropped
or damaged. to avoid the risk of electric shock, do not disassemble the
iron, take it to a qualified serviceman for examination and repair. or, call
the appropriate toll-free number listed on the cover of this manual.
incorrect reassembly can cause a risk of electric shock when the iron is
used.
□ close supervision is necessary for any appliance being used by or
near children. do not leave iron unattended while connected or on an
ironing board.
□ Burns can occur from touching hot metal parts, hot water, or steam.
use caution when you turn a steam iron upside down or use the surge
of steam — there may be hot water in the water tank. avoid rapid
movement of iron to minimize hot water spillage.
SPECIAL INSTRUCTIONS
□ to avoid a circuit overload, do not operate another high-wattage
appliance on the same circuit.
□ if an extension cord is absolutely necessary, a 10-ampere cord should
be used. cords rated for less amperage may overheat. care should
be taken to arrange the cord so that it cannot be pulled or tripped
over.
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS.