Initial installation, English – Toshiba BL712 User Manual

Page 14

English - 13 -

English

Initial Installation

Before switching on the television put your decoder and media recorder to Standby if they are connected

and ensure the aerial or cable is connected to your television. To set up the television use the buttons on

the remote control as detailed on page 7.

IMPORTANT: Ensure that the aerial or cable is
connected and a Common Interface module is not
inserted before switching on the TV for the fi rst time
installation.

Connect the mains plug and switch the T

V on

using the standby switch. If the TV does not switch
on, press any numbered or standby button on the
remote control, then the language selection menu
will be displayed. This screen will appear the fi rst
time that the television is switched on and each
time the television is reset.

By pressing the

2. Up or Down buttons highlight the

language you want to set and press OK button.
The following message will be displayed next:

By pressing

3. Left or Right button, select the

country you want to set and press Down button
to highlight the Search Type option. Use Left or
Right to set the desired search type. Available
search types are digital only, analog TV only
and full.
When set,

4. Down buton to select Teletext

Language. Use Left or Right button to select
desired Teletext Language.
Press

5. OK button on the remote control to continue

and the following message will be displayed on
the screen:

Select

6. Yes by using Left or Right buttons and

press OK to continue. Afterwards, the following
OSD will be displayed on the screen (*):

If you select

7. Cable option, the following screen

will be displayed (*) :

You can select frequency ranges from this

screen. For highlighting lines you see, use Up or
Down button. You can enter the frequency range
manually by using the numeric buttons on the
remote control. Set Start and Stop Frequency as
desired by using numeric buttons on the remote
control. After this operation, you can set Search
Step as 8000 kHz or 1000 kHz. If you select
1000 kHz, the TV will perform search process
in a detailed way. Searching duration will thus
increase accordingly.
If you select

9. Aerial option from the Search Type

screen, the television will search for broadcasts.
(*) When finished, press OK button to start
automatic search.

A01_MB65_[GB]_(IB_QSG)_DVB-TC_(3910UK_46975LED)_GOLD14_10079756_50224163.indd 13

28.07.2012 10:19:28