Toshiba LX830 - Manual (Page 49)

To load discs, follow the steps as detailed below:
1.
When the computer’s power is on, press the eject button to open the
disc tray slightly.
2. Grasp the disc tray gently and pull until it is fully opened.
Figure 3-3 Pressing the eject button and pulling the disc tray open
2
1
1. Eject button 2. Disc tray
3. Lay the disc in the disc tray with its label facing to the front of the
computer.
Figure 3-4 Inserting a disc
1
1. Laser lens
When the disc tray is fully opened, the edge of the computer will cover the
disc tray slightly. Therefore, you will need to turn the disc at an angle when
you place it in the disc tray. After seating the disc, however, make sure it
lies flat.
Do not touch the laser lens or any portion of its surrounding casing as
this could cause misalignment.
Prevent foreign objects from entering the drive. Check the surface of
the disc tray, especially the area behind the front edge of the disc tray,
to make sure there are no such objects before closing the drive.
User's Manual 3-7