beautypg.com

Preparation of the remote control – Toshiba SDP94D User Manual

Page 30

background image

30

P

repar

ations

Preparation of the remote control

Insert the specified battery to the remote control. See
page 8 for safe use of coin-shaped batteries.

1

Gently insert a fingernail in groove 1

and pull out the holder in direction 2 .

Take care not to break your fingernail.

2

Place a coin-shaped

battery (CR2025) with the

side up on the holder.

Keep the holder horizontal so that
the battery does not fall through.

CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the same or
equivalent type.

3

Insert the holder into the remote control.

The remote control battery contains Perchlorate
Material - special handling may apply.

Operating with the remote control

Point the remote control at the remote sensor and press
the buttons.

Distance: About 3 m (9.9 feet) from the front of the remote

sensor

Angle:

About 30° in each direction of the front of the

remote sensor

Do not expose the remote sensor of the player to a strong light
source such as direct sunlight or other illumination. If you do
so, you may not be able to operate the player via the remote
control.

Do not drop or give the remote control a shock.

Do not leave the remote control near an extremely hot or humid place.

Do not spill water or put anything wet on the remote control.

Do not disassemble the remote control.

If the remote control does not function correctly or if the operating

range becomes reduced, replace the battery with new one.

Inserting a battery other than the specified one or an object may

damage the remote control.

2

#

6

Backside

1

2

Within about 3 m (9.9 feet)

SDP94DTWB_E_01-56.indd 30

SDP94DTWB_E_01-56.indd 30

2010/06/03 9:30:38

2010/06/03 9:30:38