Toshiba Tecra R10 - Manual (Page 197)

User’s Manual G-3
TECRA R10
4. If the “ Please click [OK] to run the TOSHIBA Cooling
Performance Diagnostic Tool to check the cooling
performance of your PC.
” message is still displayed after running
the “TOSHIBA Cooling Performance Diagnostic Tool” in step 3, it is
recommended you turn off the computer and contact TOSHIBA support.
Cleaning the cooling module
This section explains how to clean the cooling module.
To clean the cooling module, follow the steps detailed below:
1. Shut down the computer - make sure the Power indicator is off (refer to
the Turning off the power section in Chapter 1, Getting Started , if
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel and turn the computer upside down.
4. Remove the battery pack (refer to the Replacing the battery pack
section in Chapter 6, Power and Power-Up Modes , if required).
5. Loosen the one screw securing the Cooling module cover.
6. Slide your fingernail or a thin object under the cover and lift it off.
Figure G-1 Removing the cooling module cover
If you use the computer for a long period, the inside of the computer may
become hot. Always allow the computer to cool to room temperature
before you clean the cooling module.
Use a point size 0 Phillips screwdriver.
Cooling module cover
Screw