Installing batteries in the remote control, Switching dvd / vhs mode, About the remote control – Toshiba DVR70 User Manual
Page 12

12
EN
Installing Batteries in the Remote
Control
Install two R6 (AA) batteries (supplied) into the remote
control, carefully match with the polarity indicated inside the
battery compartment.
Caution
• Incorrect use of batteries can result in hazards such as
leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus (+) and minus (–) ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used for a
month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions for
environmental protection that apply in your country or area.
• Do not recharge, short-circuit, heat, burn or disassemble
batteries.
• Make sure there is no obstacle between the remote control
and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
• The maximum operable range as follows:
• Remote control operation may become unreliable if the
remote control sensor of the unit is being exposed by the
strong sunlight or fluorescent light.
• Remote controls for different devices can interfere with each
other. Be careful when using remote controls for other
equipment located close to the unit.
• Replace the batteries when the operating range of the
remote control reduces.
Switching DVD / VHS mode
You must select which component you want to operate first.
Press [DVD] or [VCR] on the remote control or the front
panel.
Press [DVD] on the remote control.
Press [VCR] on the remote control.
Note
• You can also press [SELECT] on the front panel to switch
between DVD and VHS mode.
About the Remote Control
Line of sight:
approximately 7 m
Either side of centre: approximately 7 m within 30 degrees
2
1
3
OPEN/CLOSE
ON/STANDBY
VCR
DVD
Within
about 7 m
7 m (30°)
7 m
7 m (30°)
DVD
VHS
OPEN/CLOSE
ON/STANDBY
VCR
DVD
PROGRAM
DUBBING
SELECT
DVD
DVD
VCR
REC
REC
VCR
USB
DV IN
SELECT
DVD
VCR
Device select indicators
indicator
DVD button
VCR button
button
E9TK2FD_EN.book Page 12 Wednesday, July 29, 2009 12:16 PM