Toshiba SATELLITE P500 User Manual
Page 146
User’s Manual
8-7
Optional Devices
Installing a memory module
Follow the steps below to install a memory module.
1. Set the computer to boot mode and turn off the power.
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Chapter 6,
4. Loosen the screws securing the memory module cover.
5. Slide your fingernail or a thin object under the cover and lift it off.
Removing the memory module cover
6. Fit the module's connectors into the computer's connectors at about a
45 degree angle. Press the module carefully to ensure a firm
connection.
7. Push the module down so it lies flat. Latches on either side will click into
place to secure the module.
1
1. Memory Module Cover
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
Slot A is reserved for main memory. Use slot B for expanded memory. If
only one card is installed, use slot A.