Belkin F1DP116Gea - Manual (Page 56)

52
Video Configuration and Settings
Refresh
You may need to refresh the video image when changing the display attributes of
a target server.
To refresh the video settings:
1.
In the quick-access toolbar, click .
2. Select “Refresh” or press “Crl+R”.
Manual Video Adjust
You may want to manually adjust video to fine-tune the target-server video
settings, to adapt to a noisy environment or a non-standard VGA signal, or when
using a full-screen DOS/CLI mode.
To adjust the video manually:
1.
In the quick-access toolbar, click .
2. Select “Manual video adjust”. A slider bar will appear (see Fig. 18). A
red frame will also appear around the screen. This represents the screen
area according to the server’s screen resolution.
3. Move the sliders to adjust and change the displayed image. Click in the
area of the sliders for fine-tuning.
• Brightness/Contrast— adjusts the brightness and contrast of the
displayed image
• Horizontal Offset— defines the starting position of each line on the
displayed image
• Vertical Offset— defines the vertical starting position of the
display image
• Phase— defines the point at which each pixel is sampled
• Noise Level— represents the video noise when a static screen
is displayed
• Automated Adjust— when this box is checked, the video adjusts
automatically whenever there is a change in the screen resolution.
Using the Switch from a Remote Console