Bush Hog GC-250 - Manual (Page 17)

A. Remove the collection hose and boot assembly
from the deck and the inlet tube by loosening the
hose clamp and sliding the hose off the inlet tube..
B. Raise the top and remove bags, if bags contain
debris empty them. Lay bags aside and close top.
With the aid of another worker lift the grass catcher
frame and top assembly from the hitch.
NOTE: The grass catcher hitch does not need to be
removed from the mower.
C. Re-attach the original grass delector. Refer to
(Figure 18). If the original grass deflector has been
misplaced, lost or damaged please see your nearest
Bush Hog Dealer and order a replacement grass
deflector kit before operating this machine.
Figure 18
4-6 Removal of the Weight Kit
! !
WARNING!
The front weight and holder brackets must
be removed when the ZT is in use without
the grass catcher attached.
Operation of the ZT with the weight kit in
place without the grass catcher could
cause loss of traction and steering control
resulting in injury or death.
A. Begin by removing the two pan head screws that
secure the foot panel to the frame front crossmember
(Figure 2). Retain the fasteners for reinstallation. Lift
the floor panel off the frame and lay aside for reinstalla-
tion.
B. Remove the weight from the weight brackets See
(Figure 4).
NOTE: The front weight is 3” x 4” x 18” long and
weighs approximately 60 pounds. If you are not
capable of lifting 60 pounds with ease, get help to
perform this step.
C. Remove the weight mounting brackets.
D. Re-install the foot panel.
Original Grass Deflector Attaching Pin
1/8” x 1” Cotter Pins
3/8” Flatwashers
SECTION V
MAINTENANCE
5-1 Maintenance Checklist
Before each use:
1. Check blades and spindles to be sure that no for-
eign objects, such as wire or steel strapping
bands, are wrapped around them.
2. Inspect blades for wear. Replace if necessary. If it
is necessary to sharpen blades, remove the
blades from the spindles before sharpening. DO
NOT sharpen blades while still attached to the
mower.
3. Make sure all shields are in place and in good
condition. Repair or replace any missing or dam-
aged shields.
4. Listen for abnormal sounds, which might indicate
loose parts, damaged bearings, or other dam-
age.Correct any deficiency before continuing operation.
5. Check for wear or deterioration of the hose. If there
are any portions of the hose that have been torn or
worn through, replace with genuine BUSH HOG parts.
After Each Use:
1. Clean all debris from machine especially from the
collection bags, and off of safety decals. Replace any
missing or illegible decals.
2. Inspect the unit for worn or damaged compo-
nents. Repair or replace before next use. Any
replacement component installed during repair
shall include the component’s current safety
decal specified by the manufacturers to be
affixed to the component.
Parts And Service Information
Bush Hog Grass Catcher owners should record the
name and telephone number of their dealer. Your deal-
er will be happy to supply replacement parts, acces-
sories and do any service or repairs to your Grass
Catcher. If for any reason your dealer is unable to ser-
vice your Grass Catcher or supply replacement parts,
contact Bush Hog and include the following information
from the serial number plate:
Model Number______________________________
15