Connections – Pioneer CD-UB100 User Manual

Page 14

Important

! Use this unit in other than the following condi-

tions could result in fire or malfunction.
— Vehicles with a 12-volt battery and negative

grounding.

! To prevent short-circuit, overheating or mal-

function, be sure to follow the directions
below.
— Disconnect the negative terminal of the

battery before installation.

— Secure the wiring with cable clamps or ad-

hesive tape. To protect the wiring, wrap ad-
hesive tape around them where they lie
against metal parts.

— Place all cables away from moving parts,

such as gear shift and seat rails.

— Place all cables away from hot places,

such as near the heater outlet.

— Do not pass the yellow cable through a

hole into the engine compartment to con-
nect to a battery.

— Do not shorten any cables.

— Never cut the insulation of the power cable

of this unit in order to share the power to
other equipment. Current capacity of the
cable is limited.

— Use a fuse of the rating prescribed.

! IP-BUS connectors are color-coded. Be sure

to connect connectors of the same color.

! Place antenna cable as far away as possible

from the other cables to prevent noise.

! Black cable is ground. This cable and other

product

’s ground cable (especially, high-cur-

rent products such as power amp) must be
wired separately. Otherwise, fire or malfunc-
tion may result if they are accidentally de-
tached.

! Do not connect anything other than the USB

portable audio player/USB memory.

! Plug the terminal of the USB portable audio

player/USB memory firmly into the connector
to connect, otherwise this unit may not work
properly or an error may be displayed on the
head unit.

Cord function may differ according to the pro-
duct, even if cord color is the same. When con-
necting this system, be sure to check all
manuals and connect cords correctly.

Connections

Section