Bushnell ImageView 11-0833 - Manual (Page 8)

8
Taking Still Photos
After following the initial setup as described in the previous pages, you are ready to take a photo:
Raise the LCD and press the 1. POWER button briefly (red LED lights, Bushnell logo screen appears, then
display goes black). Press the Display button to turn on the LCD again if you want to see a preview of the
“live” image or check menu settings, battery condition, etc via the display icons.
The ImageView will default to high resolution and quality settings, as well as “everything on automatic” 2.
when it is turned on for the first time, so you can take excellent photos right away. If you prefer to use
different settings, refer to the section “Using the Main Menu” for directions regarding how to find and
change settings such as resolution and exposure and other options.
You may compose your photo while looking through the binocular (the LCD does not need to be 3.
on to take a photo). However, for the most accurate framing, checking the LCD preview display is
recommended.
Be sure you are not closer than approximately 50 feet from your subject. The binocular optics will focus 4.
closer than this, but the camera focus is preset to take photos of distant subjects (no focusing is necessary
for the camera). The LCD may be used to verify that the subject is not too close for sharp results.
Hold the camera as steady as possible with both hands and slowly squeeze the 5. SNAP button. The
display will “freeze” briefly while the file is stored, then you are ready to take another photo. The 4-digit
counter on the lower left will count down to indicate the number of remaining photos as you use up the
available internal or card memory. Once the display indicates “Memory Full” when SNAP is pressed, you
are out of memory (storage space) and should download any photos you wish to keep so they may be
deleted, or you may remove the full card and install another SD card.
Digital zoom up to 3x is available. Press the 6. Down arrow key to zoom in (note the “Wide to Tele” indicator
bar at the bottom of the display). Press the Up arrow key to zoom back out. No digital zoom is used
(optical magnification only) when the W>T zoom indicator bar goes out after you zoom all the way back
to the left (“W”).