Two-year limited warranty – Bushnell ImageView 11-0833 User Manual

Page 18

TWO-YeAR LIMITeD WARRANTY

Your Bushnell

product is warranted to be free of defects in materials and workmanship for two years

after the date of purchase. In the event of a defect under this warranty, we will, at our option, repair

or replace the product, provided that you return the product postage prepaid. This warranty does

not cover damages caused by misuse, improper handling, installation, or maintenance provided by

someone other than a Bushnell Authorized Service Department.
Any return made under this warranty must be accompanied by the items listed below:

1) A check/money order in the amount of $10.00 to cover the cost of postage and handling

2) Name and address for product return

3) An explanation of the defect

4) Proof of Date Purchased

5) Product should be well packed in a sturdy outside shipping carton, to prevent

damage in transit, with return postage prepaid to the address listed below:

IN U.S.A. Send To:

IN CANADA Send To:

Bushnell Outdoor Products

Attn.: Repairs

9200 Cody

25A East Pearce Street, Unit 1

Overland Park, Kansas 66214

Richmond Hill, Ontario L4B 2M9

For products purchased outside the United States or Canada please contact your local dealer for

applicable warranty information. In Europe you may also contact Bushnell at:

Bushnell Germany GmbH

European Service Centre

Mathias-Brüggen-Str. 80

D-50827 Köln

GERMANY

Tel: +49 221 995568-0

Fax: +49 221 995568-20

This warranty gives you specific legal rights.

You may have other rights which vary from country to country.

FCC Note:

This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However,

there is no guarantee that interference will not occur

in a particular installation. If this equipment does

cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to try

to correct the interference by one or more of the

following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment and

receiver.

· Connect the equipment into an outlet on a circuit

different from that to which the receiver is

connected.

· Consult the dealer or an experienced radio/TV

technician for help.

The shielded interface cable must be used with the

equipment in order to comply with the limits for

a digital device pursuant to Subpart B of Part 15 of

FCC Rules.

Specifications and designs are subject to change without

any notice or obligation on the part of the manufacturer.