Pioneer X-SMC00DAB-W - Manual (Page 25)

Using the tuner 08
25
En
To recall a memorised station
1 Press PRESET +/– to select the desired
station.
To scan the preset stations
The stations saved in the memory can be scanned
automatically. (Preset memory scan)
1 Press and hold PRESET +/–.
The preset number will appear and the programmed stations
will be tuned in sequentially, for 5 seconds each.
2 Press PRESET +/– again when the desired
station is located.
To erase entire preset memory
1 Press TUNER on the remote control.
2 Press CLEAR until “MEM CLR” appears.
Note
• All stations will be erased.
Listening to the DAB+
About DAB+ (Digital Audio
Broadcasting)
Digital Audio Broadcasting is a digital transmission system
where audio signals are converted to digital signals for
broadcasting. DAB+ is broadcast as a group of data called
multiplex (ensemble) which may contain one or more stations
(services). Each station contains a primary service and there
may be one or more secondary services. This allows several
programmes or services to be transmitted on a single
frequency.
Auto Scan
When turned on for the first time, the unit scans radio
stations automatically to create a station list. You can make
the auto scan again when you move the unit to other areas or
add multiplex channels to the station list.
1 Press the TUNER until "DAB" appears on the
display.
2 Press DAB SCAN on the remote control for
more than 3 seconds.
Auto Scan scanning begins.
After the scan:
The stations will be stored in alphanumeric order and the first
station on the list will be selected and you will hear it through
the speakers.
• To listen to other stations, see Selecting a station in the
station list below.
Note
• If no station is found, "NO SIG" appears.
• Up to 100 appears for total received stations.
Selecting a station in the station list
Once a DAB+ station is received, you can select stations in
the station list.
1 Press the TUNER until "DAB" appears on the
display.
2 Whilst receiving a DAB+ station, press the
TUNE +/– to select the desired station.
3 Within 10 seconds, press the DAB ENTER on
the remote control to tune into the desired
station.
DAB + SIGNAL
MULTIPLEX
(ENSEMBLE)
SERVICES
SERVICES
COMPONENTS
(STATIONS)
DISPLAY FOLDER
MENU
PRESET VOLUME
ST/MONO
+
MUTE
DIMMER
   
 
–
+
–
MEMORY
/PROGRAM
ENTER
SCAN ENTER DISPLAY
TUNE–
TUNE+
DAB
X-SMC_VXE8_En.book 25 ページ ２０１３年３月２５日 月曜日 午後２時１７分