Pioneer MVH-7300 - Manual (Page 13)

Using PI Seek
If the tuner cannot find a suitable station, or
the reception status deteriorates, the unit
automatically searches for a different station
with the same programming. During the
search,
PI SEEK is displayed and the sound is
muted.
Using Auto PI Seek for preset
stations
When preset stations cannot be recalled, the
unit can be set to perform PI Seek during pre-
set recall.
! The default setting for Auto PI Seek is off.
Refer to Auto PI (auto PI seek) on page 31.
Storing and recalling stations
for each band
Using the preset screen
1 Push M.C. up or down to display the preset
screen.
2 Push M.C. up or down until the desired band
( FM1, FM2, FM3 for FM or MW/LW) is displayed.
3 Use M.C. to store the selected frequency in the
memory.
Turn to change the preset number. Press and
hold to store.
4 Use M.C. to select the desired station.
Turn to change the station. Press to select.
You can also display the preset screen by pressing
HOME. Refer to Basic menu operations on page 9.
Function settings
1 Press M.C. to display the function
menu.
2 Turn M.C. to select the function.
After selecting, perform the following proce-
dures to set the function.
BSM (best stations memory)
BSM (best stations memory) automatically stores the
six strongest stations in the order of their signal
strength.
1 Press M.C. to turn BSM on.
To cancel, press M.C. again.
Regional (regional)
When AF is used, the regional function limits the se-
lection of stations to those broadcasting regional pro-
grams.
1 Press M.C. to turn the regional function on or off.
Local (local seek tuning)
Local seek tuning lets you tune in to only those radio
stations with sufficiently strong signals for good re-
ception.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the desired setting.
FM: Off
—Level1—Level2—Level3—Level4
MW/LW: Off —Level1—Level2
The highest level setting allows reception of only
the strongest stations, while lower levels allow the
reception of weaker stations.
3 Press M.C. to confirm the selection.
PTY search (program type selection)
You can tune in to a station using PTY (program type)
information.
1 Press M.C. to display the setting mode.
2 Turn M.C. to select the desired setting.
News&Info —Popular—Classics—Others
3 Press M.C. to begin the search.
The unit searches for a station broadcasting that
type of program. When a station is found, its pro-
gram service name is displayed.
PTY (program type ID code) information is listed
in the following section. Refer to the next page.
The program of some stations may differ from
that indicated by the transmitted PTY.
If no station is broadcasting the type of program
you searched for,
Not Found is displayed for
about four seconds and then the tuner returns to
the original station.
Traffic Announce (traffic announcement standby)
Regardless of the source you are listening to, you can
receive traffic announcements automatically with TA
(traffic announcement standby).
1 Press M.C. to turn traffic announcement standby
on or off.
Alternative FREQ (alternative frequencies search)
En
13
Section
03
Operating
this
unit
Operating this unit