Pioneer DCS-240 - Manual (Page 40)

Additional information 09
40
En
Tuner
Error Messages
Resetting the system
Use this procedure to reset all system settings
to the factory default.
1 Switch the system on.
2 Press STANDBY/ON while holding
down the front panel FM/AM button.
The next time you switch on, all the system
settings should be reset.
Using the language code list
Some of the language options (see Language
settings on page 22) allow you to set your
preferred language from any of the 136
languages listed in the
Language code list on
page 41.
1 Select ‘Other Language’.
2 Use / (cursor left/right) to select
either a code letter or a code number.
3 Use / (cursor up/down) to select a
code letter or a code number.
See the Language code list (next page) for a
complete list of languages and codes.
Problem Remedy
Considerable noise in
radio broadcasts. • Connect the AM antenna (refer to the Setup Guide) and adjust the direction
and position for best reception. You may also connect an additional internal
or external AM antenna (refer to
Connecting auxiliary components on
page 26).
• Fully extend the FM wire antenna, position for best reception, and secure to
a wall. You may also connect an outdoor FM antenna (see
Connecting external
antennas on page 27).
• Turn off other equipment that may be causing the noise or move it further
away.
•
Australian model only – The tuning interval is incorrect for your country or
region. Try switching the tuning interval (frequency step) (see Frequency step
setting on page 37).
Auto tuning does not
pick up some stations. • The radio signal is weak. Auto tuning will only detect radio stations with a
good signal. For more sensitive tuning, connect an outdoor antenna.
Message Description
REC MODE • An operation is prohibited because the Recording Mode is on (page 27).
SND DEMO • The sound demo is on. See General in Troubleshooting on page 38.
CANNOT • An operation is prohibited because headphones are connected, or TEST
TONE is pressed during disc playback.
STEREO • An operation is prohibited because the DVD/CD function isn’t selected.
TRAY LOCK • The tray lock is on. Contact your Pioneer authorized dealer for instructions.
MUTING • An operation is prohibited because the sound is muted (press MUTE ).
EEP ERROR • Contact your Pioneer authorized service center or your dealer for servicing.
EXIT • Appears when a menu is automatically exited after a set period of inactivity.
XV-DV232_240_131.book 40 ページ ２００４年１２月２４日 金曜日 午後５時２１分