Pioneer DEH-P77MP - Manual (Page 41)

Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Press AUDIO to select 80Hz.
Press AUDIO until 80Hz appears in the dis-
play.
# When the subwoofer output is on, you can se-
lect 80Hz.
2 Press ROTARY ENCODER to select cut-
off frequency.
Each press of ROTARY ENCODER selects cut-
off frequencies in the following order:
5080125 (Hz)
Only frequencies lower than those in the se-
lected range are output from the subwoofer.
3 Rotate ROTARY ENCODER to adjust the
output level of the subwoofer.
Rotate ROTARY ENCODER increases or de-
creases the level of the subwoofer. +6 6 is
displayed as the level is increased or
decreased.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this units
low pass filter (for the subwoofer), but is out-
put through the RCA output.
1 Press AUDIO to select non fading out-
put on/off setting.
Press AUDIO until NonFAD :ON appears in
the display.
# When the subwoofer controller setting is only
PREOUT:FUL, you can switch to the non fading
output on/off setting. (Refer to page 44.)
2 Press ROTARY ENCODER to turn non
fading output on.
NonFAD :ON appears in the display. Non fad-
ing output is now on.
# To turn non fading output off, press
ROTARY ENCODER.
Adjusting non fading output level
When the non fading output is on, you can ad-
just the level of non fading output.
1 Press AUDIO to select non fading out-
put setting.
Press AUDIO until NonFAD : 0 appears in the
display.
2 Rotate ROTARY ENCODER to adjust the
output level of the non fading.
Rotate ROTARY ENCODER increases or de-
creases the level of the non fading. +6 6 is
displayed as the level is increased or
decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn the HPF
(high pass filter) on. Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
1 Press AUDIO to select HPF.
Press AUDIO until HPF appears in the display.
2 Press ROTARY ENCODER to turn high
pass filter on.
HPF : 80 appears in the display. High pass fil-
ter is now on.
# To turn high pass filter off, press
ROTARY ENCODER.
Audio Adjustments
En
41
English
Section
11