Pioneer ANH-P9R-BK - Manual (Page 16)

Installing the GPS aerial
CAUTION
• Do not cut the GPS aerial lead to
shorten it or use an extension to
make it longer. Altering the aerial
cable could result in a short circuit.
Notes
• The aerial should be installed on a level sur-
face where radio waves will be blocked as
little as possible. Radio waves cannot be
received by the aerial if reception from the
satellite is blocked.
Installation on the vehicle roof or boot lid is
recommended to enable best reception.
(Fig. 10)
Fig. 10
• When installing the GPS aerial inside the
vehicle, be sure to use the metal sheet pro-
vided with your system. If this is not used, the
reception sensitivity will be poor.
• Do not cut the accessory metal sheet. This
would reduce the sensitivity of the GPS aerial.
• Take care not to pull the aerial lead when
removing the GPS aerial. The magnet
attached to the aerial is very powerful, and the
lead may become detached.
• The GPS aerial is installed with a magnet.
When installing the GPS aerial, be careful not
to scratch the vehicle body.
• When installing the GPS aerial on the outside
of the vehicle, always put it in the vehicle
when going through an automatic vehicle
wash. If it is left on the outside it may be
knocked off and scratch the vehicle body.
• Do not paint the GPS aerial, as this may affect
its performance.
Dashboard
Roof
Rear shelf
Boot lid
Installation
En 16