Pioneer A-70-K - Manual (Page 12)

04 Operation
12
En
Playing music from a digital audio
component (A-70 only)
Outputs digital signals input to the DIGITAL IN
COAXIAL
connectors.
1 Make a digital input connection.
• See Digital audio input connections on page 6.
2 Press COAXIAL to select DIGITAL IN
COAXIAL as the input source.
• When using the front panel controls, rotate the
INPUT SELECTOR knob.
• Sound is produced from the RECORDER OUT
terminals.
Note
• Digital signal formats that can be input to this unit
include linear PCM signals with sampling rates and
quantitative bits up to 192 kHz/32 bits (Depending
on the connected device and environment,
operation may not be successful).
Playing music from a computer (A-70 only)
Use this function to play digital audio input to the unit's
rear panel DIGITAL IN USB port.
1 Connect the unit to a computer via USB
cable
• See Using a USB cable to connect to a computer on
page 7.
2 Press USB to select DIGITAL IN USB as
the input source.
• When using the front panel controls, rotate the
INPUT SELECTOR knob.
• Sound is produced from the RECORDER OUT
terminals.
3 Begin playback on the computer.
Note
• When using a USB cable to connect this unit to a
computer for playing music files, the following
linear PCM digital signals are supported:
– Quantitative bits: 16 bit, 24 bit, 32 bit
– Sampling rates: 44.1 kHz, 48 kHz, 88.2 kHz,
96 kHz, 176.4 kHz, 192 kHz
• Playback cannot be controlled from this unit during
use of this function; use your computer to control
playback.
• When disconnecting the USB cable, always stop
playback on the computer first.
• Sound may not be produced if your computer does
not support USB 2.0 HS.
• This unit does not support use of a USB hub.
Always use a USB cable to connect the unit directly
to the computer.
Important
• When using the DIGITAL IN USB port to input
audio files from a computer to this unit, it may be
necessary to install a special driver on the
computer. For details, see the website of Pioneer.
Making an audio recording
You can make an audio recording from any audio source connected to the amplifier.
1 Select the source you want to record. 2 Start recording, then start playback of
the source component.
Caution
• Confirm that the short pin plugs are not inserted in
the RECORDER OUT terminals, since malfunction
will result if they are inserted.
1
MENU
iPod

 
Music>
Extras>
Settings>
Shuffle Songs Backlight
/I STANDBY/ON STANDBY iPod/USB
5V 2.1A PURE AUDIO Hi-Bit 32 FUNCTION     NETWORK AUDIO PLAYER N-50
SACD/CD player
Network audio player
Turntable
Tuner
iPod dock, etc
Audio recording component
(CD recorder, tape deck, etc.)
Playback
Recording
A70_SYXE8.book 12 ページ ２０１２年７月２７日 金曜日 午後６時５３分