Pioneer AVH-5200DVD - Manual (Page 47)

System settings
Switching the auxiliary setting
Activate this setting when using an auxiliary
device connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 39.
2 Touch AUX Input on the system menu
to turn AUX Input on or off.
Setting AV input
Activate this setting when using an external
video component connected to this unit.
1 Display the system menu.
Refer to Introduction of menu operations on
page 39.
2 Touch AV Input on the system menu to
turn AV Input on or off.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Full) or subwoofer
( Subwoofer) connection. If you switch the
rear output setting to Subwoofer, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for a rear full-range
speaker connection (
Full).
1 Turn the unit off.
Refer to Basic Operations on page 10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 39.
3 Touch Rear Speaker on the system
menu to switch the subwoofer output or
full-range speaker.
# When no subwoofer is connected to the rear
output, select
Full (full-range speaker).
# When a subwoofer is connected to the rear
output, select
Subwoofer (subwoofer).
# When the rear output setting is Subwoofer,
you cannot operate the following procedure.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to Using subwoofer output on page
41).
! If you change this setting, subwoofer output
in the audio menu will return to the factory
settings.
! Both rear speaker lead outputs and RCA rear
output are switched simultaneously in this
setting.
Setting the FM tuning step
Normally, the FM tuning step employed by
seek tuning is 50 kHz. When AF or TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
! The tuning step remains at 50 kHz during
manual tuning.
1 Select the Radio source.
Refer to Basic Operations on page 10.
2 Display the system menu.
Refer to Introduction of menu operations on
page 39.
3 Touch FM Step on the system menu to
select the FM tuning step.
Touching
FM Step will switch the FM tuning
step between 50 kHz and 100 kHz. The se-
lected FM tuning step will appear.
En
47
Section
11
Menu
operations
Menu operations