Pioneer AVH-5200DVD - Manual (Page 36)

Making a call by entering
phone number
(Function of AVH-5200BT)
Wed 28 may
1 12:45 PM
ABCDEHGHI
012345678901
01
1 2 3
4 5 6
7 8 9
* 0 #
+ C
Off
Important
Be sure to park your vehicle in a safe place and
apply the parking brake when performing this op-
eration.
1 Switch to the entering phone number
mode.
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
2 Touch the number icons to input the
numbers.
# Up to 24 digits can be entered.
3 Make the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
4 End the call.
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
Note
Entering phone number mode cannot be oper-
ated unless a Bluetooth telephone is connected
to this unit.
Setting the private mode
(Function of AVH-5200BT)
During a conversation, you can switch to pri-
vate mode (talk directly on your cellular
phone).
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
Pairing from this unit
(Function of AVH-5200BT)
Connection
01: Phone1
02: Phone2
03: Phone3
04: Phone4
05: Phone5
1 Display the Bluetooth Connection
Menu.
Refer to Introduction of Bluetooth telephone op-
erations on page 23.
2 Touch Connection to select a device.
3 Start to search.
Starting to search.
While searching, is displayed and when
available devices are found, the device names
or BD addresses (if names cannot be ob-
tained) are displayed.
# If you want to switch between the device
names and BD addresses, touch the icon.
Switching between the device
names and BD addresses.
# To cancel searching, touch Stop.
# If five devices are already paired,
Memory Full is displayed and pairing cannot be
performed. In such cases, delete a paired device
first. Refer to Deleting a paired device. on the next
page.
# If no device can be found, Not Found is dis-
played. In such cases, check the status of the
Bluetooth device and search again.
4 Touch a device name to select the de-
vice you want to connect to.
While connecting,
Pairing is displayed. If the
connection is established, Paired is displayed.
# If the connection fails, Error is displayed. In
such cases, try again from the beginning.
En
36
Section
10 Detailed instructions