Pioneer CU-RF100-U - Manual (Page 13)

Controlling the rest of your system 03
13
En
English
Note
• You can cancel or exit any of the steps by
press and hold MULTI OPERATION for a
couple of seconds. To go back a step, press
RETURN.
• After one minute of inactivity, the remote
automatically exits the operation.
Operating multiple receivers
The remote control included with this receiver
can be used to operate up to three other
receivers (of the same model as this receiver)
in addition to this receiver. 1 The receiver to be
operated is switched by inputting the preset
code to set the remote control setting.
• Set the remote modes on the receivers
before using this function (see receiver’s
operating instructions).
1 Check that the remote control’s MULTI-
ZONE selector switch is set to MAIN and that
the operation selector switch is set to
RECEIVER.
2 While pressing MULTI OPERATION, press
HOME MENU.
The remote display shows
SETUP MENU.
3 Use / to select ‘CHANGE RC MODE’,
then press ENTER.
4 Use / to select the remote mode.
RC MODE 1 to 4 can be selected.
5 Press ENTER to set the remote mode.
The selected mode flashes for 3 seconds.
To operate another receiver, start over from
step 1 to input its preset code.
Setting the remote to control
other components
Most components can be assigned to one of
the input function buttons (such as
DVD or
CD) using the component’s manufacturer
preset code stored in the remote.
However, there are cases where only certain
functions may be controllable after assigning
the proper preset code, or the codes for the
manufacturer in the remote control will not
work for the model that you are using.
If you can’t find a preset code that matches the
component you want to control, you can still
teach the remote individual commands from
another remote control (see Programming
signals from other remote controls on page 14).
• Devices may be assigned to the following
input function buttons.
READ
PRESET ID The preset codes set for the different
input functions can be checked. See
Confirming preset codes on page 16.
CHANGE
RC MODE If you have multiple Pioneer receivers,
amplifiers, etc., this setting can be used
to prevent other units from operating
simultaneously when the remote control
unit is operated. See Operating multiple
receivers on page 13.
EXIT
SETUP Exits the setup menu.
Note
1 This function is only valid when RECEIVER is set to IR MODE at the remote control’s IR/RF SELECT setting (page 7).
Setting What it does
RECEIVER SOURCE MAIN
MULTI
OPERATION
ZONE2 3
INPUT SELECT
PHONO VIDEO CD-R IN
AUX
DVD
iPod
USB OPTION
MULTI CH
ADAPTER
NET RADIO
CD
TUNER
HMG
BD
TV
HDMI DVR
BDR
1 2
MULTI
OPERATION
CU-RF100.book Page 13 Wednesday, March 17, 2010 6:13 PM