Bush Hog 1145 - Manual (Page 39)

ASSEMBLY
1145 01/11 Assembly Section 3-7
© 2011 Alamo Group Inc.
ASSEMBL
Y
Attaching Pin on Bucket
Always wear safety glasses when removing or installing buckets.
Always use a drift and hammer made of non-sparking material (a shot-filled mallet is
recommended) to install or remove pins. A steel hammer to drift could generate flying
material fragments and result in injury. Always wear safety glasses when using a hammer to
remove or install pins.
Material bucket can be installed using tools ordinarily available.
1. Attach bucket to lift boom frame and bucket cylinders with four 1” pins, 5-16 x 1-3/4 cap screws and 5-16
lock nuts (Supplied with loader).
2. Install level indicator rod in level guide tube on right bucket cylinder. Sandwich level indicator rod angle
between right inside bucket ear and cylinder rod end.
3. Set bucket level on ground and adjust level guide tube along bucket cylinder until end of guide tube is flush
with end or rod.