Assembly, Assembl y – Bush Hog 1145 User Manual
Page 37
ASSEMBLY
1145 01/11
Assembly Section 3-5
© 2011 Alamo Group Inc.
ASSEMBL
Y
6.
Remove linch pins and 1” hitch pins from loader upright.
7.
Start tractor engine and release brakes. Retract bucket cylinders to allow parking stands to contact ground.
8.
Extend lift cylinders 6” to 8” to rotate top of
loader uprights forward out of the mount,
allowing tractor to be pushed rearward. Retract
bucket cylinders until lower loader upright pins
clear mount pin saddles and front tires (See
Figure Asm-L-0026).
9.
Move tractor rearward approximately 6”, being
certain not to stretch hydraulic hoses.
10. Stop tractor engine and set parking brake.
Relax lift cylinders and bucket cylinders by
moving each control lever in both directions.
Disconnect hydraulic hoses from tractor.
11. Start tractor engine and release brakes. Slowly
back tractor out of loader.
- HS1742 (1 page)
- RTNR (20 pages)
- TDR-11 (19 pages)
- RDTH SERIES RDTH 84 (28 pages)
- RMB1865E (67 pages)
- CBH60 (56 pages)
- TOUGH 665H (1 page)
- RTH72-03 (1 page)
- Tough 3545 (33 pages)
- ZERO TURN MOWERS (30 pages)
- 965H (42 pages)
- RFM 60 (20 pages)
- Tough CZ2555 (1 page)
- 300 (62 pages)
- FC-0014 (96 pages)
- 2847 (33 pages)
- Great Bend 284 (1 page)
- 1947 (102 pages)
- TOUGH Subcompact Rear Blades (6 pages)
- TOUGH 1847QT (1 page)
- TOUGH 2346QT (1 page)
- Tough 2846QT (1 page)
- 1747 (30 pages)
- TOUGH RTNR80 (1 page)
- RTS62-04 (1 page)
- 5045 (56 pages)
- RDTH84 (1 page)
- RTN72 (1 page)
- RTC (20 pages)
- TOUGH TD-1700 (1 page)
- EFM 60 (20 pages)
- FTH 600 (20 pages)
- Mid-Mount Loaders 5045 (1 page)
- 2297 (125 pages)
- 2387 (104 pages)
- Tough ATH720 (1 page)
- 3327 (100 pages)
- PT5 (80 pages)
- 2185 (1 page)
- RDTH60 (20 pages)
- 2045 (85 pages)
- Tough SMP73 (2 pages)
- TOUGH CLR60 (1 page)
- TOUGH 2447QT (1 page)