Pioneer RMX-1000-M - Manual (Page 7)

7 En
Editing
Effects
Editing Effects
SCENE FX section
1
5
2
3
4
! The contents displayed on the screen differ according to the effect type.
1 FX LOCK button
This is used to select whether or not to use the effect type selection
buttons’ accidental operation prevention function.
2 Effect type selection buttons
These are used to select the type of effect to be edited.
3 SCENE FX control section
This is used to adjust the [SCENE FX] control’s parameters.
4 SUB PARAMETER 1 control section
This is used to adjust the [SUB PARAMETER 1] control’s parameters.
5 SUB PARAMETER 2 control section
This is used to adjust the [SUB PARAMETER 2] control’s parameters.
Editing the parameters
1 Click one of the effect type selection buttons.
Select the type of effect to be edited.
2 Operate the pull-down menus, etc., to select the
setting value.
Change the effect’s parameters.
! For details on the parameters’ adjustment range, see SCENE FX
under Effect parameter adjustment ranges at 12.
Using the effect type selection buttons’
accidental operation prevention function
Click the [FX LOCK] button.
The [FX LOCK] button lights.
When the accidental operation prevention function is enabled, effects
can be turned on and off by pressing and holding the effect type selec-
tion buttons on the RMX-1000.