Using direct listening, Using the balance and tone controls, Playing other sources – Pioneer A-A6MK2-K User Manual
Page 12: Making an audio recording, Listening to your system, Listening to your system 04, Chapter 4

Listening to your system
04
12
En
Chapter 4:
Listening to your system
Using Direct listening
Use the Direct listening feature when you want
to hear the truest possible reproduction of a
source. All unnecessary signal processing
1
is
bypassed, and you’re left with the pure sound
source.
•
While listening to a source, press DIRECT
to switch Direct listening on or off.
Using the balance and tone
controls
Depending on what you are listening to, you
may want to adjust the bass, treble or left/right
balance using the remote control.
•
Press TONE/BAL to select the option you
want, then use the L/– and R/+ buttons to
adjust as necessary.
•
BASS – Adjust the amount of bass from
–10 to +10.
•
TRE – Adjust the amount of treble from
–10 to +10.
•
BAL – Adjust the amount of left/right
balance as you like.
FLAT indicates a
centered balance.
Wait about five seconds for your changes to be
input automatically. The
BASS and TREBLE
indicators light in the front panel when the
corresponding tone control is active.
• To return to the flat setting (tone control
off), press
L/– and R/+ at the same time.
Playing other sources
1
Turn on the power of the playback
component.
2
Turn on the power of the amplifier.
3
Select the source you want to playback.
Use the input select buttons (or
INPUT
SELECTOR dial).
4
Start playback of the component you
selected in step 1.
Making an audio recording
You can make an audio recording from any
audio source connected to the amplifier.
1
Select the source you want to record.
Use the input select buttons (
INPUT
SELECTOR).
2
Prepare the source you want to record.
Tune to the radio station, load the CD, set up
the turntable, etc.
3
Prepare the recorder.
Insert a blank tape, MD, etc. into the recording
device and set the recording levels.
2
Refer to the instructions that came with the
recorder if you are unsure how to do this.
4
Start recording, then start playback of the
source component.
Note
1 The balance and tone controls are disabled, and the front panel display switches off.
2 The amplifier’s volume, balance and tone controls have no effect on the recorded signal.
A6MK2_SYXCN5.book 12 ページ 2009年4月7日 火曜日 午前11時18分