Connecting antennas plugging in, 02 connecting up, Connecting antennas – Pioneer SX-20-S User Manual
Page 6: Plugging in
02
Connecting up
6
En
Connecting antennas
Connect the AM loop antenna and the FM wire antenna
as shown below. To improve reception and sound
quality, connect external antennas (see Using external
antennas below).
1
Push open the tabs, then insert one wire
fully into each terminal, then release the
tabs to secure the AM antenna wires.
2
Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the direction
indicated by the arrow then clip the loop onto the stand.
3
Place the AM antenna on a flat surface
and in a direction giving the best reception.
4
Connect the FM wire antenna into the
FM antenna socket.
For best results, extend the FM antenna fully and fix to a
wall or door frame. Don’t drape loosely or leave coiled
up.
Using external antennas
To improve FM reception
Use a PAL connector (not supplied) to connect an
external FM antenna.
To improve AM reception
Connect a 5 m to 6 m length of vinyl-coated wire to the
AM antenna terminal without disconnecting the
supplied AM loop antenna.
For the best possible reception, suspend horizontally
outdoors.
AM LOOP
FM UNBAL
75
ANTENNA
2
3
4
1
FM UNBAL
75
ANTENNA
75 Ω coaxial cable
One-touch PAL
connector
AM LOOP
Outdoor antenna
5 m to 6 m
Indoor antenna
(vinyl-coated wire)
Plugging in
CAUTION
• Do not use any power cord other than the one
supplied with this unit.
• Do not use the supplied power cord for any purpose
other than that described below.
Important
• When going on a trip or otherwise not using the
unit for an extended period, always disconnect the
power cord from its outlet. Note that various
internal settings will not be lost even if the power
cord is disconnected from its outlet for an extended
time.
• If it is necessary to detach the power cord, first be
sure to press /I STANDBY/ON on the front panel
so receiver is turned OFF.
After you’ve finished making all connections, plug the
unit into an AC outlet.
1
Plug the supplied power cord into the
AC IN socket on the rear panel of the unit.
2
Plug the other end into an AC outlet.
AC IN
To AC outlet
Power cord