Black & Decker ElectroMate 90556511 User Manual

Page 6

ACCESSORIES

Recommended accessories for use with your tool are available from your local dealer or authorized service center.
If you need assistance regarding accessories, please call: 1-800-544-6986.

WARNING: The use of any accessory not recommended for use with this tool could be hazardous.

SERVICE INFORMATION

All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and
reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts,
contact the Black & Decker location nearest you. To find your local service location, refer to the yellow page
directory under "Tools—Electric" or call: 1-800-544-6986 or visit www.blackanddecker.com.

FULL TWO-YEAR HOME USE WARRANTY

Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship.
The defective product will be replaced or repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased
(provided that the store is a participating retailer). Returns should be made within the time period of the retailer’s
policy for exchanges (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with
the retailer for their specific return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or authorized Service
Center for repair or replacement at our option. Proof of purchase may be required. Black & Decker owned and
authorized Service Centers are listed under "Tools-Electric" in the yellow pages of the phone directory and on our
website www.blackanddecker.com.
This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other
rights which vary from state to state or province to province. Should you have any questions, contact the
manager of your nearest Black & Decker Service Center. This product is not intended for commercial use.
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call
1-800-544-6986 for a free replacement.

SPECIFICATIONS

12 Volt DC Specifications
Battery:

12 volt DC rechargeable, maintenance-free

Internal Battery Type:

Sealed, AGM lead-acid

Internal Battery Capacity:

12 volt 17Ah/20 hour rate

Area Light :

Light Emitting Diode (LED)

Jumper Cables:

Heavy duty cable with 450 amp clamps

Accessory Outlet Protection:

5 amp, dual self-resetting breakers

DC Charging Adapter:

12 volt DC

AC Power Specifications
Output Power:

Continuous — 400 watts

TROUBLESHOOTING GUIDE

Jump Starter

120 Volt AC Accessory Outlet (Inverter)

12 Volt DC Accessory Outlets

Inflator

Problem

Possible Cause

Solution

Inflator turns ON, but will not inflate
the tire

Chuck is not properly inserted into
tire valve

Remove chuck and make sure it is
properly inserted into tire valve.

Inflator will not turn ON

• Inflator is overheated

• Unit’s internal battery is depleted

• Turn Inflator OFF. Wait

approximately 10 minutes for it to
cool down; then turn back ON.

• Recharge unit (refer to the

“Charging/Recharging” section of
this instruction manual).

Problem

Possible Cause

Solution

Accessory Outlet will not power
appliance

• Excessive load

• Unit’s internal Battery is depleted

• Unplug appliance. Wait

approximately 10 minutes for
Accessory Outlet to cool down.
Reduce load to 60 watts/5 amps.

• Recharge unit (refer to the

“Charging/Recharging” section of
this instruction manual).

Problem

Possible Cause

Solution

No AC output; green LED is lit

Battery voltage below 10.5 volts

Recharge unit (refer to the
“Charging/Recharging” section of
this instruction manual).

No AC output; green LED is flashing Excessive load – thermal shut down Unplug appliance(s). Wait

approximately 10 minutes for
Accessory Outlet to cool down.
Reduce load to 400 watts.

Motorized power tool won’t start

Excessive start-up current

Appliance will not work with
inverter.

Snow in television picture;
“buzz” in audio speaker(s)

Interference

Keep inverter and antenna distant
from each other, use shielded
antenna cable connect antenna to
amplifier.

Inverter initially powers, then
automatically shuts down

Equipment being operated draws
too much power

Reduce load to maximum 400 watts

Problem

Possible Cause

Solution

Jump starter will not jump start a
vehicle

ON/OFF switch is not in the ON
position

Turn ON/OFF switch in the rear of
the unit to the ON position.

Unit beeps continuously when
connected to a car battery

Cables are connected incorrectly,
activating the Reverse Polarity
Alarm

Disconnect the cables/clamps and
match the polarity of the clamps
with the polarity of the battery
before attempting to reconnect
according to the vehicle’s battery
specifications.

Unit doesn’t turn on

Unit’s internal battery is depleted

Recharge unit (refer to the
“Charging/Recharging” section of
this instruction manual).

Output Voltage:

120 VAC RMS

Output Frequency:

60 Hz ±4 Hz

Output Waveform:

Modified sine wave

Overheat Protection:

Yes

Overload Protection:

Yes

Output Short Circuit Protection:

Yes

Tire Inflator Specifications
Maximum Pressure:

120 PSI

Battery Charger Specifications
Input:

120 volt AC, 60 Hz

Rapid Charging Current:

12 volt DC 1000mA

See ‘Tools-

Electric’

– Yellow Pages –

for Service &

Sales

Imported by

Black & Decker (U.S.) Inc.,

701 E. Joppa Rd.

Towson, MD 21286 U.S.A.

90556511 VEC026BD.qxp:VEC026BD ManualENSP 061808 12/11/09 2:02 PM Page 10