Olympus X-44 - Manual (Page 57)

57 EN
3 Any request for repair by a customer in same
country where the product was purchased shall
be subject to the terms of the warranty issued by
the Olympus distributor in that country. Where
the local Olympus distributor does not issue a
separate warranty or where the customer is not in
the country where the product was purchased the
terms of this worldwide warranty shall apply.
4 Where applicable, this Warranty is valid
worldwide. The Olympus authorized service
stations listed in this Warranty will gladly honor it.
* Please refer to the appended list for the
authorized international Olympus service
network.
Disclaimer of Warranty
Olympus makes no representations or
warranties, either expressed or implied, by or
concerning any content if these written materials
or software, and in no event shall be liable
for any implied warranty of merchantability or
fi tness for any particular purpose or for any
consequential, incidental or indirect damages
(including but not limited to damages for loss
of business profi ts, business interruption and
loss of business information) arising from the
use of inability to use these written materials or
software. Some states do not allow the exclusion
or limitation of liability for consequential or
incidental damages, so the above limitations
may not apply to you.
Trademarks
IBM is a registered trademark of International
Business Machines Corporation.
Microsoft and Windows are registered trademarks
of Microsoft Corporation.
Macintosh is a trademark of Apple Inc.
SDHC logo is a trademark.
All other company and product names are
registered trademarks and/or trademarks of their
respective owners.
The standards for camera fi le systems referred to
in this manual are the “Design rule for Camera File
system/DCF” standards stipulated by the Japan
Electronics and Information Technology Industries
Association (JEITA). •
•
•
•
•
•