Install the o-ring – Olympus PT056 User Manual
Page 18
EN 18
EN
Install the O-ring
Confirm that no foreign matter is in the gap and then fit the O-ring. At this
time, confirm that the O-ring does not stick out from the groove.
When sealing this product, make sure that no hairs, fibers, sand particles
or other foreign matter stick not only to the O-ring, but also to the contact
surface (front cover). Even a single hair or a single grain of sand may
cause water leakage. Please check with special care.
PT-056_EN.book Page 18 Thursday, February 13, 2014 11:12 AM