Olympus LS-14 - Manual (Page 43)

3
1,3
2
P
la
yback
43
EN
Playback
Notes
• When you skip to the beginning of the file during
playback, the recorder stops at the position of the
index mark or temp mark. Index marks and temp
marks are skipped when you perform this operation
in stop mode (
☞ P.44).
• When [ Skip Space ] is set to a setting other than
[ File Skip ], the recorder skips forward/reverse by
the specified time and then starts playback (
☞ P.70).
About music files
▌
In cases where the recorder is unable to play back
music files that have been transferred to it, check to
make sure that the sampling rate and bit rate are in
the range where playback is possible. Combinations
of sampling rates and bit rates for music files which
the recorder can play back are given below.
File format
Sampling
frequency
Bit rate
WAV format
44.1 kHz, 48.0 kHz 16 bit
88.2 kHz, 96.0 kHz 24 bit
MP3 format
MPEG1 Layer3:
32 kHz, 44.1 kHz,
48 kHz
MPEG2 Layer3:
16 kHz, 22.05 kHz,
24 kHz
From 8 kbps up to
320 kbps
• Variable bit rate MP3 files (in which conversion bit
rates can vary) may not be played back properly.
• For WAV files, this recorder can only
play back those in the linear PCM format. WAV files
other than these cannot be played back.
• Even if the file format is compatible for playback on
this recorder, the recorder does not support every
encoder.
Changing the playback speed
The tone will be automatically adjusted digitally
without changing the voice so it sounds natural.
1
While the recorder is in playback
mode, press the OK button.
2
Press the + or − button to select
playback speed.