Seal the case, Attach the diffuser, Check the operation of the loaded camera – Olympus PT-EP10 User Manual
Page 15

EN 14
EN
Seal the Case
1
Close the Case gently while aligning the mounting projection of the rear lid and groove of the open/close dial.
2
Turn the open/close dial counter clockwise.
• The Case is sealed.
Attach the diffuser
• Do not cap to optical fiber cable insertion slot.
Check the operation of the loaded camera
After sealing the Case, check that the camera operations normally.
• Push the ON/OFF button on the Case and confirm that the camera turns ON/OFF.
• Turn the mode dial knob on the Case and confirm that the camera mode switches properly.
• Press the shutter lever on the Case and confirm that the camera shutter releases.
• Operate the zoom dial on the Case and confirm that the camera’s lens is controlled.
• Operate other control buttons on the Case and confirm that the camera functions properly as intended.
CAUTION:
• If the open/close dial is not fully turned, the Case will not be sealed. This will cause water leakage.
• Close the rear lid of the Case so that the lens cap or LCD hood strap is not caught. If it is caught, water
leakage may be caused.
Close
PT-EP10_EN.Book Page 14 Thursday, September 20, 2012 5:44 PM