Beko 40WLU550FHID - Manual (Page 18)

16
6.4.2.2-If you do not know the
channel number
Press the MENU button. Move
to the SETUP menu by pressing
the Down movement button in
the Main Menu and confirm your
selection with the OK button.
Setup menu will be displayed.
Select the system in which you
would like to make the search
from the SYSTEM tab. Move into
CHANNEL tab by pressing the
Down movement button. Press OK
on your remote control to select
“ S” for cable channels and “C” for
channels received via the antenna.
Select SEARCH tab using the Up/Down
movement buttons, and scan the channels
in ascending order with Right movement
button and in descending order with Left
movement button. If the channel that is
found is of your liking, select the STORE tab.
Then store it in the memory by pressing the
Right or Left movement buttons. Repeat
the same procedure for other channels by
selecting the program number of your choice
from the PROGRAM NO tab. If the channel
you found is not of the desired quality and
requires Fine Tuning or if you would like to
rename the channel, refer to the relevant
sections.
6.4.3-Fine Tuning
If the channel you found is not of
the desired quality and requires
Fine Tuning, then select the FINE
TUNE tab by pressing the Down
movement button in the Setup
menu. Using the Left/Right
movement buttons on your remote
control, adjust the broadcast
displayed on the screen to your
desired quality. Under normal circumstances,
you will not require to use the Fine Tune
function. The AFC values of your television
will automatically adjust and lock themselves
to the channel. However, you might need
it in case the television transmitters do not
operate according to the standards. To store
in the memory the settings you have made,
select the Store tab and press the Right or
Left movement button.
To stop the process at any given time,
please press the MENU button. The
Program Table, which will allow you to sort
the channels as you wish, will be displayed
after the automatic search is complete.
6.4.2-Manual tuning of channels and
storing in the memory
6.4.2.1-If you already know the
channel number
Press the MENU button. Move to the
SETUP menu by pressing the Down
movement button in the Main Menu and
confirm your selection with the OK button.
Setup menu will be displayed.
AUTOPROGRAM
SEARCHING
% 20
STOP
SETUP
CHANGE BACK
SYSTEM
CHANNEL
FINE TUNE
SEARCH
PROGRAM NO
STORE
AUTOPROGRAM
I
S06
0
P13
Select the system in which you
would like to make the search
from the SYSTEM tab. Move into
CHANNEL tab by pressing the
Down movement button. Press OK
on your remote control to select
“ S” for cable channels and “C” for
channels received via the antenna.
Move onto the PROGRAM NO tab
and using the number buttons enter
the channel number in which you
would like to have the channel stored. If the
broadcast viewed on the screen is of your
desired quality, first move onto the STORE
tab with the down movement button to
store in the memory the selection you have
made and store the channel by pressing
the Left or Right movement buttons. The
prompt STORED will be displayed briefly.
The channel will be stored according to the
program number of your choice. You can
tune and store in memory other channels the
same way. In the event that you wish to exit
the channel settings menu for any reason,
simply press the EXIT button.